Ademco 4140XMPT2 Trouble Display

6F - Long Range Radio trouble

NO AC AC Power Failure

BAT Backup Battery low

BAT 01 - 63 Zone has low battery (If 4 zones show at once likely Keyfob low battery)

BAT 00 Low Remote Keypad battery

CHECK 01 - 63 Wireless zone not communicating with panel

CHECK 87 4285 Voice Module Trouble

CHECK 97 Short in Polling Loop

CHECK 88 Wireless Zones not communicating with 2nd Receiver

CHECK 89 2nd Receiver Failure

CHECK 90 Wireless Zones not communicating with 1st Receiver

CHECK 91 1st Receiver Failurel

D1 or

SYSTEM BUSY System in wait mode, if it stays on system has internal problem

CA Alarm was canceled, this is not a trouble

CC Panel is being downloaded by Tech Support

EA Exit Alarm, this is not a trouble, customer armed system

left and didn't close door before delay expired

FC Fail to Communicate

E4 or E8 More zones were programmed than wireless receiver is capable of

OC Open Circuit, bad keypad wire

One Beep System is in Test Mode (Press Code + 1 to exit Test Mode)

every 40 Sec

Smoke Remove old batteries, hold Smoke test button 30 seconds, Insert new batteries

Batteries