Silent Knight SK5204 Basic Commands

System can be operated using built-in touchpad (see main panel diagram) or 5230 remote keypad

User Code 1111

SK5230 Keypad Commands Panel Keypad Commands

Silence Alarms 7 + ENTER + User Code 7 + ENTER

or or

SILENCE + User Code SILENCE

Reset Alarm 1 + ENTER + User Code 1 + ENTER + User Code

Clear Alarm Memory 2 + ENTER + User Code 2 + ENTER

Alarm Memory 5 + ENTER + User Code 5 + ENTER

Display Trouble 6 + ENTER + User Code 6 + ENTER

Silence Troubles SILENCE + User Code SILENCE

Enable/Disable Zone Zone (1 to 4) + DISABLE + User Code Zone (1 to 4) + DISABLE + User Code

System Test 0 + ENTER + User Code 0 + ENTER

Reset Dialer 3 + ENTER + User Code + 0 or 1 3 + ENTER + User Code + 0 or 1

Walk Test 2 + 2 + ENTER + Installer Code 2 + 2 + ENTER + Installer Code

Set Date 1. 8 + ENTER + User Code 1. 8 + ENTER

2. Enter 6 digit date (MM/DD/YY) 2. Enter 6 digit date (MM/DD/YY)

3. Press CLEAR CLEAR to exit 3. Press CLEAR CLEAR to exit

Set Time 9 + ENTER + User Code + 6-digit time 9 + ENTER + User Code + 6-digit time

1st Digit = Day (0 = Sunday, 1 = Monday etc) 1st Digit = Day (0 = Sunday, 1 = Monday etc)

2nd Digit = AM/PM (0 = AM, 1 = PM) 2nd Digit = AM/PM (0 = AM, 1 = PM)

3rd to 6th = HHMM 3rd to 6th = HHMM

Press STEP STEP CLEAR CLEAR to exit Press SILENCE SILENCE CLEAR CLEAR to exit

Display Codes (on Main Panel)

0 to 16 = Zone (with Alarm, Alarm Memory or Trouble LED)

E0 = Trouble with Dialer

E1 = Trouble with External Printer

E7 = Trouble with EEPROM Memory

F0 = Keypad Power Trouble

F1 to F7 = Trouble with a particular Keypad

A1 to A4 = Trouble with a particular Bell Output

P1 = Trouble with Smoke Power

P2 = Trouble with Accessory Power

P3 = Earth Ground Fault to Circuit Ground

P4 = Earth Ground Fault to Power

Po = Printer out of Paper

dL = Communicator lost data it was trying to transmit

dF = Communicator Failure

dc = Low Battery

Ac = Low AC Power

L1 = Phone Line 1 Fault

L2 = Phone Line 2 Fault

Keypad Display -0 = Fire Drill

-2 = Walk Test

-4 = Downloading

-5 = Zone Test

-6 = Hex Programming Mode

-8 = Set Date Mode

-9 = Set Time Mode